Fitment Years 2006 - 2011

Fits To OEM / Scorpion

Pipe Diameter 70mm/2.75"

Non Resonated (Louder)

 

  • Spray all bolts, hanging rubbers and joints with lubricant and allow time to penetrate
  •  If your vehicle has an electronic or vacuum exhaust valve, this will need to be disconnected
  • NOTE: Some O.E exhausts are installed as one piece before the rear axle is installed, and will need to be cut before they can be removed. Detailed instructions will be included if cutting is required
  • Loosen all bolts and clamps
  •  Remove the original exhaust system starting from the rear of the car and working to the front
  • Original exhaust systems can be heavy due to the materials they are made from, and the size of silencers. Take care when removing the exhaust to avoid any damage to your vehicle
  • NOTE: On certain vehicles, it can be difficult to pop the exhaust out of the hangers, you may find it easier to remove the bracket assembly from your vehicle
  • Begin to install the Scorpion system, working from the front to the rear of your vehicle
  • We recommend smearing a small amount of high-temperature silicon inside each slotted/slip joint. This will help prevent any leaks and prevent pipework from seizing together
  • Loosely tighten the clamps as you are fitting the system
  • Start your vehicle up in a well ventilated area and leave to tick over for around 10 - 15 minutes
  • Check the system for any leaks
  • Take your vehicle for a test drive, and drive at various engine speeds to allow the exhaust to settle in properly
  • Allow the exhaust to partially cool down, and then re-check that all joints are adequately tightened and ensure there are sufficient clearances around the exhaust system

 

Part Number SSTS008

 

Fits

Seat Leon 1.4Tsi 2006-2011

Seat Leon 1.4Tsi Exhaust CatBack Also fits 1.6i & 2.0Fsi

SKU: CT14TSISCEXCATBACKNONRES
£534.01Price
<